valve end
英 [vælv end]
美 [vælv end]
网络 气门杆端部
双语例句
- True Union Valves-remove valve; CAREFULLY tighten seal carrier ( located on inlet end of body).
单进入阀门-小心紧固单活接头螺母。 - These include complete valve assembly, less union nuts and end connectors.
这些包括完整的阀门总成，但不包括活接头螺母和端口连接件。 - The valve's seat is at the opposite end from the handle.
阀门的阀座位于手柄对面的另一端。 - Apply silicon sealer/ lubricant to the inner and outer diameters of the flange kit gasket, and press the gasket onto the valve body end. A new skeleton-based method for tiling the unmatched contours is developed that will produce a more natural physical model.
将硅密封/润滑剂施加在法兰组件垫圈的内径和外径上，将垫圈压在阀体端口上。本文提出的基于骨架的末端封闭方法，可以得到更符合物体自身形状的三角网格模型。 - "Keep heat in, windows and doors shut" A spring on the valve stem tends to hold the valve on its seat ( closed). The lower end of the spring rests against the cylinder head.
防止热气外溢，请关门窗气门杆上的弹簧使气门保持在气门座上（关闭状态）。弹簧的下端抵在气缸盖上。 - Under normal circumstances, angle-regulating valve are being installed, that is, at the end into the side.
一般情况下，角型调节阀均采用正向安装，即底进侧出。 - Tube wells in the ground, first install the valve connecting the end of tube wells three, in the well pipe at the top of the order to install valves and killing head and hands;
在地面的井管上，首先安装底阀连接井管三通，在井管上方依次安装阀门和和手压井头； - Safety valve's inlet butt end shall be supplied by seller.
安全阀入口焊接坡口尺寸由卖方提供。 - Loosen the valve union nuts and slide them back over the end connections.
松开阀门的管接头螺母，并将其滑回到端口连接件上。 - This welding machine is used for welding parts in applications of valve element, in-out water pipe fittings at end covers of solar water heaters, automobile and motorcycle manufactures.
该系列管接头电脑自动氩弧焊机适用于气阀阀芯、太阳能热水器端盖进出水管接头焊接、并广泛应用于汽车制造、摩托车制造等行业。 - Each must have stainless steel valve stem and decoration The valve should be provided with a waterproof housing and the end flange connection, unless otherwise indicated.
每个阀须有不锈钢干和装饰阀门应具有防水住房和提供法兰连接结束，除非另有说明。 - Students check the automatic drain valve of the front end of the valve is open.
检查自动排水阀前端之球阀是否打开。 - Allows easy conversion of valve end connections due to system change, modification, or inadvertent misorder of product.
如果系统需要改变，修正，或者由于疏忽错订了产品，则采用这种套件能够轻易地转换阀门端口连接件。 - The external nozzle mechanism comprises a three-way valve for connecting the tail end of the steam outlet pipeline, a beverage straw and a nozzle respectively.
外置式喷嘴机构包括三通阀，分别连接三通管的一端、饮料管和喷嘴。 - A gas valve is provided at the rear end of the airbrush for controlling the mixed gas.
喷枪体的后部设有控制混合气体的气控阀。 - Indirect valve gear End play in drive pinion bearings.
间接式气门驱动机构驱动小齿轮轴承的端隙。 - When the vapor is discharged by the pressure-limiting valve, the high temperature is discharged upward from the top end, and the man standing on the side to adjust firepower is not hurt.
当蒸汽由限压阀排出时，高温汽体由顶端向上排放，不会伤到站在侧面调节火力的人； - Flap valve is mainly installed in the end of drainage pipeline to prevent extra water flow backward.
拍门主要安装在排水管道的尾端，用于防止外水倒灌。 - The valve can be used in either direction on dead end service.
这种阀门能够双向应用，也可以应用在终端场合。 - The style of main part furnace was outer cycle, and some parts of calciner were optimized, such as setting outlet valve in end of the furnace, enlarging contact area between ring and serving wheel, installing three rows of heating pipes with wings in the furnace.
煅烧炉型为外返式，并对炉体局部进行了优化：炉尾设出料阀，加大滚圈与托轮的接触面积，炉内设置三排带翅片的加热管。 - Hypothesizing the portion of the end valve is closed instantly, the transient pressure in the end of pipeline is extracted based on induced response method.
基于激励响应法，假定管道末端阀门快速部分关闭，求出了出管道末端处的瞬态压力响应。 - In this system, a MCU is used to control the turning and positioning of the stepping motor. The stepping motor then turns the valve on the hot end of the vortex tube to control the cold flow fraction and outflow temperature of the vortex tube.
在系统中，对单片机编程实现了四相步进电机的转向及定位控制，再由步进电机驱动涡流管热端阀改变其开度，从而达到控制涡流管冷流率及出口温度的目的。 - Study on Weld Technology and Materials for Strengthening of Engine Valve End
气门杆端面焊接工艺及材料研究 - The paper puts forward a simple but practical and cost-effective scheme about the application and control way of the overhaul signal valve and the end water testing device in the automatic sprinkler system.
本文就自动喷水灭火系统中检修信号阀和末端试水装置的应用和控制方式提出了简便实用，经济有效的具体方案。 - Research on stability of valve regulating at the end of water conduit system
输水系统末端设置阀门控制的稳定性研究 - In the flow out system, the flow lines between tank and filling hose are installed in straight line and are equipped with a non-return foot valve at the end to the tank.
出油系统中，油罐与加油机之间的出油管呈直线布置，出油管在罐内的末端须加单向底阀。 - Study for the continuously varied valve opening speed of the lock end filling systems
集中输水系统船闸阀门缓变速开启方式的研究 - The squeezing stress between the valve end the screw for adjusting valve clearance must be taken into account in designing high speed valve train.
高速配气机构设计中一个不可忽视的薄弱环节是气门间隙调整螺钉头部的挤压疲劳。 - Based on the valve opening of the end equipment AHU, the frequency of the pump is controlled over the change of the pressure difference value of index circuit.
根据末端设备AHU的阀门开度信号来改变最不利环路末端压差设定值，从而实现对水泵频率的控制。 - As for structure, a new cylinder supported bearing structure has been proposed, and a new kind of fixed valve plate which is fixed on the end cap of pump has been developed.
结构上，提出了新的缸内支撑轴承式结构，设计了一种固定安装于后端盖的固定式配流盘。